POSIFLEX DT-207 series, User Manual, Page: 16 / 20

Part 16
MSR (OPTION)
The MSR option if installed is located in between the programmable
keyboard and the display unit. There is a mark aside the MSR slot indicating
that the magnetic stripe of the card to be read should be facing the display unit.
For card reading operation, be sure to insert the card to the bottom of the slot
with magnetic stripe of the card near the bottom edge. The movement of an
ISO card can be either inserting the card from the left end then sliding the card
to the right out of the slot, or sliding the card from the right to the left as long
as the card is a standard one. A non-standard card recorded without complete
degaussing prior to recovery may accept only one direction in card reading.
RFID (OPTION)
This option can only be applied to the flat type keyboard model and is
located in the right area of the keyboard assembly where a mark for the RFID
reader is printed. Place the tag over that mark for operation if this option is
installed.
TOUCH PANEL
All paragraphs below are applicable for DT-208 with touch panel
only. The user of those models without touch panel (i.e. DT-207) can ignore
them and consider this user’s manual ends here.
Mechanical Support
The mechanical structure of the display unit in DT system can hold
the display unit firmly for DT-207. However, for the touch function in DT-208,
extra support of a steel wire is required to offset the external touch force.
Please pick the display unit support steel wire from its rest ditch on back of the
display unit and turn it down to sit into any pair of the troughs on the UPS
battery cover and cable cover.
Mouse Emulation
The touch panel in DT system uses PS/2 interface. When the touch
driver is properly installed, this touch panel works exactly like a standard PS/2
mouse. However, if the system is running under safe mode, most drivers are
disabled in this mode and the touch panel calibration is therefore not
guaranteed. It is recommended to use a standard USB mouse or keyboard in
this mode.
All the below mentioned mouse emulation functions can be
manipulated through relevant software. The system can give a beep and a click
on the left button of a mouse at the point when the touch panel is touched
except in WinCE or Linux environment. If the point touched is dragged across
the screen surface, it works as the mouse drag and drop feature. If the point is