POSIFLEX DT-207 series, User Manual

Page: 7 / 20

Part 7
INSTALLING PD-201 (OPTION)
Please first have a qualified technician to open
the jumper setting service window on the bottom plate as
marked in the left picture and set a DC + 5V support to
the COM port that the PD-201 is to be connected to
according to Posiflex technical information.
Please then open the cable cover and push at the
2 latches toward the
system front as
marked in the right
picture to remove
the UPS battery cover to show the UPS
battery cavity as in the right picture below.
Take the removed UPS battery
cover as the below picture and push at the
2 latches down to remove the customer
display cover installed on it and result as
the leftmost picture further below.
Now take the PD-
201 and first pass its interface cable to go through the square opening in the
UPS battery cover and insert the 2 lugs at front bottom of PD-201 as arrowed
in the middle picture above into the correspondent positions arrowed in the
leftmost picture above then press down the 2 latches on rear bottom of PD-201
down till they firmly click in the UPS battery cover as in the rightmost picture
above. Please double check if the PD-201 is well inserted.
Before installing the PD-201 + UPS battery cover assembly into the
DT system top cover, please check the bottom side
of the PD-201 + UPS battery cover assembly to
route the interface cable in between the guide posts
on the UPS battery cover as indicated in the left
picture.
UPS
Battery
Cover
PD Cover Taken Off PD-201