BIOS Setup Information
ROBO-8777VG2A User’s Manual
4-13
On-Chip Secondary PCI IDE
The chipset contains a PCI IDE interface with support for two IDE channels. Select
Enabled to activate the primary IDE interface. Select Disabled to deactivate this
interface.
The choice: Enabled, Disabled.
IDE Primary/Secondary Master/Slave PIO
The four IDE PIO (Programmed Input/Output) fields allow set a PIO mode (0-4) for
each of the four IDE devices that the onboard IDE interface supports. Modes 0
through 4 provide successively increased performance. In Auto mode, the system
automatically determines the best mode for each device.
The choice: Auto, Mode 0, Mode 1, Mode 2, Mode 3, Mode 4.
IDE Primary/Secondary Master/Slave UDMA
Ultra DMA/33/66/100 implementation is possible only if IDE hard drive supports
and the operating environment includes a DMA driver (Windows 95 OSR2 or a
third-party IDE bus master driver). If your hard drive and system software both
support Ultra DMA/33/66/100, select Auto to enable BIOS support.
The choice: Auto, Disabled.
LEGACY Mode Support
Certain OS is not support under Native mode.
The choice: Disabled, Enabled.
Phoenix- AwardBIOS CMOS Setup Utility
Super IO Device
Item Help
Onboard FDC Controller
[Enabled]
Onboard Serial Port 1
[3F8/IRQ4]
Onboard Serial Port 2
[2F8/IRQ3]
UART Mode Select
[Normal]
X RxD, TxD Active
Hi, Lo
X IR Transmission Delay
Enabled
X UR2 Duplex Mode
Half
X Use IR Pins
IR-Rx2Tx2
Onboard Parallel Port
[378/IRQ7]
Parallel Port Mode
[SPP]
X EPP Mode Select
EPP1.7
X ECP Mode Use DMA
3
Menu Level
f
↑↓→←
: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
