Troubleshooting
ROBO-8713BVG2 User’s Manual
5-5
Question: After done with installation of SATA hard disk device, why does
system BIOS show nothing on screen?
Answer:
As matter of fact, you need to access system BIOS to enable SATA device.
(Please refer to SATA hard disk device installation guide)
Question: I am using an ATA-66 (or 100) hard drive, how can I know that ATA-66
function is enabled?
Answer:
You need to use the 80-pin ATA-66 IDE flat cable to have this function.
During the Post stage, you can see ATA-66 (or 100) message while hard
drive is being detected. Besides, after successfully installing Microsoft
series OS, you also need to install ATA-66/100 driver to active ATA-
66/100 function.
Information & Support
Question: I have one IDE hard disk and one SATA hard disk. How can I assign
SATA hard disk as First boot device?
Answer:
After entering system BIOS, access Advanced BIOS Feature. And then
press enter on Hard disk boot Priority. You will see the mode of your
SATA hard disk. Select it as first boot device.
Besides, please also notice. Every time, when your hard disk devices
have been changed, system bios will ask you to re-setup Hard disk boot
priority.
Question: Intel 865 series Chipset supports Dual Channel Mode, but how can I
enable this function?
Answer:
Indeed, you don’t have to change any setting. You can simply plug in two
DDR RAM Module, and then system will automatically enable Dual
Channel Mode.
Question: What kind of CPU supports Hyper-Threading?
Answer:
All FSB 800 MHz series CPU support Hyper-Threading mode. AS for FSB
533 MHz, CPU must be over 3.06 GHz.
Question: Why cannot I install USB 2.0 driver?
Answer:
If you are using Windows 2000, you need to update your Service-Pack
version to Service-Pack 4. If you are using Windows XP, you need to
update Service-Pack to Service Pack 1 at least.
