PEB-7600VG2A User’s Manual
2.2.9 External USB3 & USB4 (USB2.0)
This mainboard provides 2 USB headers on the board allowing for 4 additional USB ports. To make use of these headers, you
must attach a USB bracket/cable with USB ports (some models will come packaged with a USB 4-port bracket-cable). The
optionally packaged bracket will have two connectors that you can connect to the headers (USB1, USB2). The other end
(bracket containing the USB ports) is attached to the computer casing.
Note :
If you are using a USB 2.0 device with Windows 2000/XP, you will need to install the USB 2.0 driver from the
Microsoft
®
website. If you are using Service pack 1 (or later) for Windows
®
XP, and using Service pack4 (or later) for
Windows® 2000,you will not have to install the drive
r.
2.2.10 USB & (Gb) LAN Connectors: USB/ Gb LAN 1&2
This mainboard comes with 4 USB ports and a Gb/s LAN port. The USB connectors are used to attach to keyboards, mice and
other USB devices. You can plug the USB devices directly into this connector. The LAN connectors can be attached directly to
a network.
Pin Signal
Description Pin Signal
Description
1 TX+ 5 NC
2 TX- 6 RX-
3 RX+ 7 NC
4 NC 8 NC
Pin Signal
Description Pin Signal
Description
1/5
+5 V (fused)
3/7
USBP0+/P1+
2/6
USBP0-/P1-
4/8
Ground
2.2.11 SATA1-4 (Serial ATA connector)
These SATA connectors (SATA1 – SATA4) support Serial ATA 150. Each SATA connector can only support one serial ATA
device.
Note
: With most storage devices, there is a power cable that you need attach to a power source (power supply).
2.2.12 Audio Port Connectors: Sound
PIN No.
Signal Description
1 SPO
2 VCC5
3 NC
4 GND
2.2.12.1 Audio in
PIN No.
Signal Description
1 CD-L
2 CD-GND
3 CD-GND
4 CD-R
５
