PEB-7600VG2A User’s Manual
Chapter 2 System Installation
This chapter provides you with instructions on how to setup your system. The additional information shows you how to
install CPU/ FAN and memory .
2.1 Socket 775 Processor
2.1.1 Installing Pentium 4 / Celeron D CPU
(1). Lift the handling lever of CPU socket outwards and upwards to the other end.
(2). Align the processor pins with pin hones on the socket. Make sure that the notched corner or
(3). dot mark (pin 1) of the CPU corresponds to the socket’s bevel end. Then press the CPU gently until it fits into place. If
this operation is not easy or smooth, don’t do it forcibly. You need to check and rebuild the CPU pin uniformly.
(4). Push down the lever to lock processor chip into the socket.
(5). Follow the installation guide of cooling fan or heat sink to mount it on CPU surface and lock it on the socket 775.
(6). Be sure to follow particular CPU speed and voltage type to adjust the jumper settings properly.
Having figured out in general what you get, the next job is to bite the bullet and build your PC
2.1.2 Precautions
When integrating a Pentium 4 processor-based system, be sure to take the proper
electrostatic discharge (ESD) precautions. Consider using ground straps, gloves,
ESD mats, or other protective measures to avoid damaging the processor and other
electrical components in the system.
Warning
Do not touch socket sensitive contacts. Chain tech assumes no responsibility for the potential
damages caused by this action and therefore the warranty we provide may be invalid.
2.1.3 Installing CPU
#1
Disengage Load Lever by depressing down and out on the hook to clear retention tab.
Rotate Load Lever to fully open position at approximately 135°
#2
Rotate Load Plate to fully open position at approximately 100°. Remove Socket Protective Cover. With left hand index
finger and thumb to support the load plate edge, engage protective cover finger tab with right hand thumb and peel the cover
from LGA775 Socket while pressing on center of protective cover to assist in removal.
#3
Locate the two orientation key notches.
#4
Grasp the processor with thumb and index finger. (Grasp the edges without the orientation notches.) The socket has cutouts
for your fingers to fit into. Carefully place the package into the socket body using a purely vertical motion. (Tilting the
processor into place or shifting it into place on the socket can damage the sensitive socket contacts.)
#5
Verify that package is within the socket body and properly mated to the orientation keys
#6
Close the socket by
1. Close the Load Plate
2. While pressing down lightly on Load Plate, engage the Load Lever.
3. Secure Load Lever with Load Plate tab under retention tab of Load Lever
8
