PEB-7600VG2A User’s Manual
2.2.17 VGA D-SUB15 Connector
PIN No.
Signal Description
1 Red
Signal
2 Green
Signal
3 Blue
Signal
4 NC
5 GND
6 GND
7 GND
8 GND
9 VCC
10 GND
11 NC
12 DCC_DATA
13 HSYNC
14 VSYNC
15 DCC_CLK
2.2.18 VGA DVI Connector
Signal PIN Signal
TDC0# 2 1
VCC5
TDC0 4 3
GND
NC 6 5
NC
NC 8 7
NC
TDC1# 10 9
HPDET
TDC1 12 11 MDVIDATA
NC 14
13 MDVICLK
NC 16
15 GND
TDC2# 18 17
TLC#
TDC2 20 19
TLC
Signal Type
Signal
Description
TDC0,TDC0# O
DVI Data Channel 0 Output
: These pins provide the DVI differential output for
data channel 0 (Blue).
TDC1,TDC1# O
DVI Data Channel 1 Output
: These pins provide the DVI differential output for
data channel 1 (Green).
TDC2,TDC2# O
DVI Data Channel 2 Output
: These pins provide the DVI differential output for
data channel 2 (Red).
HPDET I
Hot Plug Detect (internal pull-down)
: This input determines whether the DVI
is connected to a DVI monitor. When terminated , the monitor is required to
apply a voltage greater than 2.4 volts. Changes on the status of this pin will be
relayed to the graphics controller via the P-OUT/TLDET* or GPIO(1)/TLDET*
pin pulling low.
TMDSDATA I/O
DVI I2C Data
: This signal is used as the I2C DOC clock for a digital display
connector (i.e. TV-Out Encoder , TMDS transmitter ). This signal is tri-stated
during a hard reset.
TMDSDCLK I/O
DVI DOC Clock
: This signal is used as the DOC clock for a digital display
connector (i.e. primary digital monitor). This signal is tri-stated during a hard
reset.
TLC,TLC# O
DVI Clock Output:
These pins provide the differential clock outputs to the DVI
interface corresponding a data on TDC(0:2) outputs.
７
