9
6. Adjust directional exhaust
deflector (A) Fig. 23, so that the
exhaust air blast will be directed
away from the operator. The exhaust
deflector provides eight detented
positions for directing the exhaust
blast away from the operator. Grasp
the deflector and rotate it to the
desired position for the current
application.
USING THE TOOL WITH SELECTABLE TRIGGERING OPTIONS
Complete all steps of PREPARING THE TOOL before using the tool.
This tool is shipped from the factory with a selectable trigger set in the
“SINGLE SEQUENTIAL ACTUATION”
firing mode as described in number
1 below. The selectable trigger can be set for the
“CONTACT ACTUATION”
firing mode as described in number 2 below;
1.
To use the tool in the
SINGLE SEQUENTIAL ACTUATION MODE
depress trigger lever pivot pin (A) Fig. 24, rotate arrow to position (B), and
release.
Note:
Trigger lever pivot pin is spring loaded and held in position by
locking tab (D) Fig. 24 to prevent movement during operation. To fire, grip
tool firmly to maintain control, position nose of tool onto work surface,
push
tool firmly against work surface to depress safety, as shown at (S) Fig.
25, and then squeeze trigger to fire a fastener
. Allow tool to recoil away
from work surface as fastener is driven. This “
single sequential actuation
”
method provides the most accurate fastener placement.
-OR-
2.
To use the tool in the
CONTACT ACTUATION MODE
depress trigger
lever pivot pin (A) Fig. 24, rotate arrow to position (C), and release.
Note:
Trigger lever pivot pin is spring loaded and held in position by locking tab (D)
Fig. 24 to prevent movement during operation. To fire, grip tool firmly to
maintain control,
squeeze and hold trigger, push tool firmly against work
surface to depress contact safety, as shown at (S) Fig. 25, and fire a
fastener
. Allow tool to recoil away from work surface as fastener is driven. If
safety element is allowed to recontact work surface before trigger is released
an unwanted fastener will be fired. The tool will fire a fastener each time the
contact safety is depressed. This method is known as “
contact actuation
”
and allows very fast repetitive fastener placement.
IMPORTANT:
A “
single sequential actuation
” trigger, which will
limit
the
tool to method number 1 only, is available free-of-charge by calling 1-800-
321-9443 in the United States and Canada or 001-731-660-9374 outside the
United States and Canada, and providing tool model number, type, serial
number, etc. For identification purposes: the
single sequential actuation
trigger is red.
OPERATING INSTRUCTIONS
Fig. 23
A
