Portable Winch 600MH, User Manual

Page: 19 / 116

EN
4
2.2.5 Starting the motor
The controls can be found on the motor's housing, above the
battery cavity.
Note : A higher speed reduces the battery's operating time.
3. Usage
Before each use :
● Check the soil consistency and the deepest possible insertion depth.
● Check the blade attachment.
● Check the attachment of the wire guide.
● Check the tire pressure.
3.1 Installing the perimeter wire spool
The Perimeter Wire Machine 600MH-Li TM is designed to
accommodate most wire spools provided by the manufacturers and
third party resellers of robot lawnmowers.
IMPORTANT: Six stepped spacers are supplied for
accommodating spools of different width and center
diameters. Select the spacers that will allow for easy insertion
of the rod and spool assembly with the most direct path to the
wire guide located behind the blade.
3.1.1
Spools mounted on a drum
The hardware provided is suitable for installation of most models up
to 800 meters (depending on the wire's diameter):
3) Remove the shaft (with the hardware). Then remove the hardware.
NOTE: Make sure the wire is dispensed from the top of the reel.
a. Spacer(s);
b. The left centering hub (towards the inside of the spool);
c. The spool (support at the right level depending on its diameter)
on the hub;
d. The right centering hub (towards the inside of the spool);
e. Spacer(s);
f. The rubber washer;
NOTE: When the adequate reel tension is set, you can tighten the handle’s
jam bolt slightly to keep it in position. Do not overtighten to prevent
damaging the threads on the rod.
3.1.2 Spools without a drum
3.1.2.1 Spools that empty through the center
Some manufacturers supply a spool designed to be emptied
through the center. Two (2) PERIMETER WIRE BOXES
18 cm x 18
cm (part PWMA-0002) and 22.5 cm x 22.5 cm (part PWMA-
0003) , available as optional accessories for the Perimeter Wire
Machine 600MH-Li TM , accepting this type of spool (up to 17.5 cm or
21 cm in diameter, depending on the box used).
A)
Operating the unit: Press twice to turn on and press
again to turn off.
B)
Press to select the speed of the motor.
Once = slow
Twice = medium
Three times = fast
1 B 1 A
THE LITHIUM-ION BATTERY IS FITTED WITH AN INTERNAL
BREAKER
WHICH AUTOMATICALLY STOPS THE
MACHINE IN CASE OF OVERLOAD. IF THIS HAPPENS,
TURN THE DEVICE OFF BY PRESSING BUTTON ''A'' (SEE
ILLUSTRATION).
1) Unscrew the clamping handle and
remove with the flat washer.
1 1
2) Lift the shaft while opening the
blocker.
2
3
4) Insert in the desired order
depending on the spool used.
4
ITS COMPACT SIZE AND LIGHT WEIGHT MEAN THE
PERIMETER WIRE MACHINE 600MH-LI
TM CAN BE EASILY
TRANSPORTED IN A SMALL VEHICLE. REMOVING THE
BATTERY IS HIGHLY RECOMMENDED WHEN DOING
THIS.
NOTE: The spool holding arm may
need to be adjusted to fit the spool and
to avoid unnecessary turning of the
handle when setting the reel tension.
5) Insert the shaft by sliding it into the
slots provided (arch and adjustable
spool support). Return the flat washer
and the clamping handle to the shaft.
Turn the clamping handle until there is
sufficient tension to prevent the spool
from free wheeling.
5