EN
6
3.1.2
Spools without a drum
3.1.2.1 Spools that empty through the center
Some manufacturers supply a spool designed to be emptied through
the center. Two (2) PERIMETER WIRE BOXES
18 cm x 18 cm (part
PWMA-0002)
and
22.5 cm x 22.5 cm (part PWMA- 0003)
, available
as optional accessories for the
Perimeter Wire Machine 600MH-Li
TM
,
accepting this type of spool (up to 17.5 cm or 21 cm in diameter,
depending on the box used).
3.1.2.2 Spools with no defined shape
Some manufacturers provide wire designed to be wound around the
drum manually. As an optional accessory for the
Perimeter Wire
Machine 600MH-Li
TM
, a
PERIMETER WIRE DRUM (part PWMA-
0001)
is available to allow the winding of the wire provided by the
manufacturer.
3.2
Moving the machine to the work zone
To move the machine to the work zone :
1) Loosen the clamping lever on the
handle;
2) Pivot the handle until it is vertical on
the machine.
3) Lift the support foot in front the
machine.
4) Pull or push the machine to the work
area.
3.3
Using the distance guide
The Perimeter Wire Machine 600MH-Li
TM
is equipped with an
adjustable distance guide. This is used to
align the machine with the edge of the
course and bury the wire at a distance
between
15 cm and 45 cm.
In addition,
the distance guide
can be placed at the
front or back of the
machine
, depending
on user preference.
To use the distance guide:
1)
Unscrew the wing nut (
See A
)
;
2)
Position the distance guide at the desired distance according to
the ruler label (on the front or back of the machine). The ruler
ensures positioning between 15 and 45 cm to the nearest
centimeter. (
See B
)
;
3)
Tighten the wing nut.
3.4
Self-propulsion
The
Perimeter Wire Machine 600MH-Li
TM
is
equipped with a transmission for self-
propulsion. This allows for a constant rate of
installation and considerably reduces operator
effort.
3.5
Inserting the perimeter wire in the wire guide
Proceed as follows:
1) Pull the end of the wire from the spool;
2) Insert the wire in the guide wire tube;
3) Push the wire until it emerges;
3.6
Burying the perimeter wire in the ground
Refer to the manufacturer's instructions of the robot mower for the
technical specifications for installing perimeter wire.
Initially, attach the end of the wire to a stake or a tool planted in the
ground.
1)
Start the motor;
2)
Lift the support foot at the front of the machine;
3)
Slowly insert the blade into the ground by pressing down on the
handle until the frame is parallel to the ground (Figure 1)
;
4)
Apply pressure to the traction handle to move the machine
(Figure 2)
.
3.7
Adjusting the handle height
It is important to adjust the handle height
before working with the
Perimeter Wire
Machine
TM
.
The recommended handle position is at the
waist level, but adjust it to your preferred
height using the handle clamping lever.
FRONT
BACK
B
B
A
1
2
