EN
5
2.2.5
Starting the motor
The controls can be found on the motor's housing, above the
battery cavity.
A)
Operating the unit: Press twice to turn on and press
again to turn off.
B)
Press to select the speed of the motor.
Once = slow
Twice = medium
Three times = fast
Note : A higher speed reduces the battery's operating time.
THE LITHIUM-ION BATTERY IS FITTED WITH AN INTERNAL
BREAKER WHICH AUTOMATICALLY STOPS THE MACHINE
IN CASE OF OVERLOAD. IF THIS HAPPENS, TURN THE DEVICE OFF BY PRESSING
BUTTON ''A'' (SEE ILLUSTRATION).
3.
Usage
ITS COMPACT SIZE AND LIGHT WEIGHT MEAN THE
PERIMETER WIRE MACHINE 600MH-LI
TM
CAN BE EASILY
TRANSPORTED IN A SMALL VEHICLE. REMOVING THE BATTERY IS HIGHLY
RECOMMENDED WHEN DOING THIS.
Before each use :
●
Check the soil consistency and the deepest possible insertion
depth.
●
Check the blade attachment.
●
Check the attachment of the wire guide.
●
Check the tire pressure.
3.1
Installing the perimeter wire spool
The Perimeter Wire Machine 600MH-Li
TM
is designed to
accommodate most wire spools provided by the manufacturers and
third party resellers of robot lawnmowers.
IMPORTANT: Six stepped spacers are supplied for
accommodating spools of different width and center diameters.
Select the spacers that will allow for easy insertion of the rod
and spool assembly with the most direct path to the wire guide
located behind the blade.
3.1.1
Spools mounted on a drum
The hardware provided is suitable for installation of most models up
to 800 meters (depending on the wire's diameter):
NOTE:
Make sure the wire is dispensed from the top of the reel.
a. Spacer(s);
b. The left centering hub (towards the inside of the spool);
c.
The spool (support at the right level depending on its diameter)
on the hub;
d. The right centering hub (towards the inside of the spool);
e. Spacer(s);
f.
The rubber washer;
NOTE:
The spool holding arm may need
to be adjusted to fit the spool and to avoid
unnecessary turning of the handle when
setting the reel tension.
NOTE:
When the adequate reel tension is set, you can tighten the
handle’s jam bolt slightly to keep it in position. Do not overtighten to
prevent damaging the threads on the rod.
2) Lift the shaft while opening the
blocker.
3) Remove the shaft (with the hardware). Then remove the
hardware.
3
4
5) Insert the shaft by sliding it into the
slots provided (arch and adjustable
spool support). Return the flat
washer and the clamping handle to
the shaft. Turn the clamping handle
until there is sufficient tension to
prevent the spool from free
wheeling.
5
B
A
4) Insert in the desired order
depending on the spool used.
2
1
1) Unscrew the clamping handle and
remove with the flat washer.
