EN
8
4.
Maintenance
Some adjustments should be performed periodically to maintain the
machine in good working condition. Here is the maintenance
schedule:
4.1
Belt adjustment
The
Perimeter Wire Machine 600MH-Li
TM
is equipped with three (3)
belts. These should be inspected and/or adjusted twenty five (25)
hours of use. In some cases, they should be replaced. The main
reasons for replacing a worn belt are: cracking, loss of material,
unraveling, uneven wear or areas shiny due to heat or slippage.
NOTE:
Do not overtighten the belts! The belt should move about 1cm
when pressure is applied in the middle of the span.
4.1.1
Adjusting the engine belt
●
Loosen the 8 bolts without
removing them
(Figure 1,2);
●
Using your hand, apply pressure
to the engine mount until the belt
is tight
(Figure 3);
●
Tighten the 8 bolts.
4.1.2
Adjusting the blade transmission belt
1)
Loosen the 6 bolts (see Figure)
;
2)
Move the blade transmission to
achieve the desired tension;
3)
Re-tighten the 6 bolts.
Maximum torque:
10 N-m (90 in-lb).
4.1.3
Adjusting the wheels transmission belt
1)
Loosen the nut with a 13 mm
wrench;
2)
Pivot the transmission on its
axis to achieve the desired
tension;
3)
Tighten the nut.
4.1.4
Lubricating the blade transmission shaft (10 hours)
Due to the vertical position of the shaft,
some grease is likely to escape during
normal use. A small amount of grease
should be added to the transmission
cap in order to deliver additional grease
to the shaft. Follow instructions included
with the grease bottle (PWMA-0009)
supplied with your PWM600MH-Li. One
bottle will last for about 10 refills.
Available as a spare part.
ONLY USE LUBRICANT PWMA-0009.
4.2
Storage
Always store the
Perimeter Wire Machine 600MH-Li
TM
on its tires.
4.3
Charger and battery
(Sold separately)
.
4.3.1 Charger
THE
BATTERY
IS
NOT
FULLY
CHARGED.
IT
IS
RECOMMENDED TO CHARGE THE BATTERY FULLY BEFORE
THE FIRST USE TO ACHIEVE MAXIMUM OPERATING TIME. THIS LITHIUM-ION BATTERY
HAS NO MEMORY AND CAN BE CHARGED AT YOUR DISCRETION.
4.3.1.1
Charging
If the battery has been stored with little charge or with no charge for
a long period, the charger enters restart mode which takes 20 hours
for the battery to be fully charged.
This prolongs the life of the battery. Once fully charged, standard
charging is available next time.
Any discharged battery requires a cooling period which is mentioned
in the battery user manual.
·
Plug the charger into the mains.
·
Insert the battery into the charger.
ACTION
BEFORE / EVERY
AFTER
Use
10
hours
25
hours
100
hours
Storage
Use
Check the blade
attachment
X
Check the wire guide
attachment
X
Check the tire pressure
X
Check the blade
X
X
Clean the top and bottom
of the machine
X
X
X
Clean underneath the
guards
X
X
X
Clean the blade
attachment system
X
X
X
Clean the inside of the
wire guide
X
X
X
Clean the tires
X
X
X
Lubricate the blade
transmission shaft
X
Inspect and adjust the
belts
X
X
Inspect and tighten bolts
and nuts
X
X
1
4
2
3
