12/02/13
U:\Instructions - CURRENT\Lifts\A3 LIFT INST 1265 V FLB.doc
PG 2 OF 11
STEP 3.
Locate the 2” X 3” X 68 1/8” top bed cross tubes. The tube with a single cable protruding from each end is
the winch bed cross tube
(REF. # 6)
. The other one with the two cables on each end is the anchor cross tube
(REF. #
7)
. From the inside of the lift frame, on the winch end, place the winch bed cross tube across the end of the lift, so
that the nylon slide angles are up against the inside corners of the side member upright tubes. Take the anchor cross
bed tube and place across the other end of the lift frame so that the bottom loops of the cable are in the cutout holes of
the bottom side tube of the side members and the nylon slide angles are against the uprights as on the other bed cross.
STEP 4.
Assembly may be easier if 2” X 4” ‘s are laid diagonally on the end across the bottom four corners of the
lift and the bed is assembled on top of the 2” X 4” ‘s.
Take the two 1” X 3” X 64 1/8” side bed tube cable assembly
tubes
(REF. # 8 & 9)
. With the cable loop end down and toward the winch end of the lift, fasten the angle end of the
side rail tube to the two holes in the bed cross tubes with 3/8” X 3” bolts, washers, & nuts
(REF. # 16, 21 & 23)
.
Place cable loops into the cutout holes of the bottom tube of the side members. Secure in place with 3/8” X 3” bolts,
and nuts
(REF. # 18 & 23)
. Secure the cable loops of the anchor bed cross tubes, on the other end of the lift with
3/8” X 2 1/2” stainless steel bolts and nuts.
(REF. # 18 & 23)
.
Using a tape measure, square
the corners of the
lift to
within 1/4” or less. Tighten all bolts at this time
.
