AIR VALVE AND PRESSURE REGULATOR ASSEMBLY
1. Remove Trigger
13
by driving out Trigger Pin
14
using 2mm (0.080") pin punch.
2. Remove Ram Sleeve Retainer Plate
34
(steps 1-4 in
RAM SLEEVE ASSEMBLY
section of this
manual).
3. Using the pin punch or a screwdriver through the Trigger opening gently push out the Pressure Regulator
39
, the Air Valve Assembly
16
, and the Valve Plug
15
.
4. Remove O-rings
7
.
ASSEMBLE IN REVERSE ORDER
Assembly Notes:
1. Lubricate all O-rings and seals prior to installation.
2. Be sure to properly position the trigger slot in Pressure Regulator
39
so that the low side is forward toward
the trigger.
3. Install the Air Valve Assembly
16
so that the holes are parallel to the Nose Housing
44
.
EMHART TEKNOLOGIES
• 50 Shelton Technology Center, Shelton, CT 06484 • Tel. (877) EMHART1 • Fax: (800) 225-5614 •
www.emhart.com
Page 13
Note:
Numbers in
bold type
refer to call out numbers in illustration.
