POP UP PUSH 10 PRO, Operator'S Safety And Maintenance Handbook

Page: 13 / 20

Page 12 PUSH PRO -0120843
TRANSPORTING THE MACHINE
PREPARING FOR TRANSPORTATION
Use the following procedure to prepare the aerial plat- form for transportation.
1 Remove any unnecessary tools, materials, or other loose objects from the platform.
2 Close and latch the component tray.
TRANSPORTING
The equipment used to load, unload, and transport the aerial platform must have adequate capacity. The empty
vehicle weight is listed in “Speci cations” on pages 16 to 18 and is stamped on the serial number placard.
The user assumes all responsibility for:
• Choosing the proper method of transportation.
• Choosing the proper selection and use of transportation and tie-down devices.
• Making sure the equipment used is capable of supporting the weight of the aerial platform.
• Making sure all manufacturer’s instructions and warnings, regulations and safety rules of their employer, the
DOT, and/or any other state or federal law are followed.
LIFTING WITH A FORKLIFT
Use the following procedure to lift the aerial platform with a forklift.
1 Properly stow the aerial platform.
2 Engage the brakes on both of the rear wheels.
3 Remove all personnel, tools, materials, or other loose objects from the platform.
4
Insert the forklift forks into the pockets on either side of the machine.
CAUTION: LIFTING THE AERIAL PLATFORM WITH THE FORKLIFT FORKS POSITIONED IMPROPERLY CAN
PRODUCE ENOUGH FORCE TO DAMAGE MACHINE COMPONENTS. WHEN LIFTING THE MACHINE WITH A
FORKLIFT, ONLY USE THE DESIGNATED LIFT POINTS.
5 Do not raise the aerial platform higher than necessary to transport it. Drive the forklift slowly and
carefully when transporting the aerial platform.
LIFTING WITH A TAIL LIFT
Use the following procedure to lift the aerial platform with a forklift.
1 Properly stow the aerial platform.
2 Remove all personnel, tools, materials, or other loose objects from the platform.
3 Position the aerial platform on the tail lift.
4 Engage the brakes on both of the rear wheels.
5 Carefully raise the lift and position the aerial platform in the transport vehicle.
6 Secure the machine to the transport vehicle using straps through the fork lift pockets.