9
Place the screw heads through the inside of the pool. Nuts should be on the outside of the pool wall.
(See diagram 14).
Only hand tighten the bolts at this point. Check to see if the pool wall is level. This can
be achieved by placing a length of rigid timber or similar across the diameter of the pool and placing
the builders level on the top.
(See diagram 15)
If the deviation is more than 2 cm
(see diagram 16)
, then the ground site must be levelled again.
Warning! A pool that is not level is very dangerous and may collapse at anytime.
Check also if the pool wall is round and measure the diameter across a few spots to make sure the
differences of diameter measured are within 2cm.
Cover the screw heads with the thick PVC band
(See diagram 17, 18)
You can also use tape to seal the screw heads.
(Diagram 15)
(Diagram 16)
(Diagram 17)
(Diagram 18)
Summary of Contents for ENDEAVOUR PREMIUM
Page 20: ......
