PoolRite innoSphere 630, Owner'S Manual

Page: 7 / 16

Connecting The Pump To Filter
1. Place filter tank on a level concrete slab having minimum dimensions as shown under SPECIFICATIONS
(Page 11).
2. Position tank filter label to the front then place pump on the left side with suction port facing front. (For
above-ground pools this may have to be rotated 180°).
3. Fit all of the moulded couplings to the innoValve ports and the pump ports.
4. Using standard PVC pressure pipe and fittings, fabricate suitable connecting plumbing between the top
pump discharge port and the PUMP port on the innoValve.
5. Make all remaining connections from the pool and waste plumbing to the pump and innoValve.
6. Remove innoValve after disconnecting PUMP, RETURN and WASTE plumbing and Split Clamp Band.
7. aTo ensure correct separation from internal standpipe assembly:
a) Lift the innoValve approximately 250mm.
b) With other hand, reach under valve then twist and pull standpipe downwards until separated.
8. Place valve and rubber gasket in a clean place.
9. Re-position bottom of standpipe assembly in bottom of tank.
10. While holding standpipe central in the neck of the tank, gently push outer ends of all lateral arms down
until they contact the tank wall.
11. Fit black moulded standpipe locater between top of standpipe and tank neck. Fit red plastic cap to top of
standpipe (this will prevent media entering standpipe during filling).
12. Quarter fill tank with water. Add the correct amount of graded M20 Diamond Kleen (refer specifications)
and distribute evenly across the bottom of the tank.
13. This should completely cover all parts of the underdrain assembly.
14. Add the correct amount of graded M10 Diamond Kleen (refer to specification), levelling the bed when
needed.
15. Remove black moulded standpipe locater, then clean all media and dust from neck area of tank.
16. Replace, rubber gasket and multiport valve.
17. Refit and tighten Split Clamp Band.
18. Re-connect PUMP, RETURN and WASTE plumbing to innoValve.
6