PoolRite innoSphere 630, Owner'S Manual, Page: 5 / 16

OPERATIONAL CHECK POINTS
Failure to adhere to the following directions will void the Warranty!
1. Filter Pump should not be connected via extension leads as damage to motor can result.
2. At least 130mm clearance must be provided at fan cowl (rear) end of motor for efficient ventilation.
3. Should the filter system be housed in an enclosure, provision must be made for adequate ventilation.
4. Filter system must be installed in a position with effective drainage to guard against potential flooding in
heavy rain or malfunctions in plumbing.
5. The pool water level must be at least half way up the skimmer box opening.
6. Make sure both skimmer box basket and pump basket are in place.
7. On initial vacuum cleaning of the pool, it is wise to use a filter sock in the pump strainer basket to prevent
excess debris damaging the pump impeller seal.
8. Do not operate the filter system in FILTER mode unless the free chlorine level is between 0.5 and 3.0 ppm
and the pH level is between 7.0 and 7.8 for concrete pools and 6.8 and 7.2 for other types of pools, or
as recommended by the Pool Builder.
9. Do not vacuum clean the pool when the filter valve is in the BACKWASH position.
10. Do not operate the filter valve handle while the pump is running.
IMPORTANT
Read the following instructions carefully to ensure trouble free efficient operation of your
filtration system for many years!
ATTENTION INSTALLER
1) BOTTOM OF INTERNAL STANDPIPE MUST BE LOCATED ON SPIGOT AT BOTTOM OF TANK
BEFORE ADDING MEDIA!!
2) THIS MANUAL MUST BE GIVEN TO THE POOL OWNER FOR COMPLETION OF WARRANTY
DETAILS!!
4