3-11
3 First Steps
11
Connection for mouse/keyboard (PS/2 interface)
Not used
12 COM1
serial interface (9-pin Sub-D plug)
Not used
13
DisplayPort connections
Not used
14
Mains connection (socket for standard power cord)
15 I/O
mains switch
3.3
Assembly
WARNING!
Danger of injury and risk of property damage caused by negligent
handling of the system!
The individual components are heavy and cumbersome. Negligent handling
can result in personal injury or property damage.
» Only lift system components in pairs or using a suitable lifting device.
» Never work under a suspended load.
» Always work in pairs.
» Always wear safety shoes and, if necessary, protective gloves during
transport, assembly and disassembly.
ATTENTION!
Damage to the device caused by insufficient opportunity for air
circulation!
Heat is created inside the device during operation. If the heat cannot escape
from the housing, a heat accumulation is being caused. This will overheat the
electronic parts inside the device and may result in a defect.
» Always keep free all air inlets and outlets of the device.
» Keep at least 50 mm distance to the wall when you set up the device.
» If the devices are in a system cabinet: Remove all covers of the system
cabinet before switching on the devices.
» If you notice a cooling fan failure, switch off the device immediately.
ATTENTION!
Thread damage caused by overtightening the screws!
If you tighten the screws too firmly, you can damage the thread.
» Only hand-tighten the screws.
» Hand-tighten means: Tighten the screw firmly so that it cannot undo itself.
Do not use excessive force and avoid damaging the thread.
