Polysoude P6 HW, Operating, Maintenance And Programming Manual, Page: 41 / 100

THE ART OF WELDING
P6 HW
PN-0110008 Rev. 12 41-100
Detection of the welding head 4. 3. 10.
If the head connected to the power source does not correspond with the welding procedure selected, the cycle
will not start.
Select the correct procedure or change the head appropriately to enable the welding cycle to start.
Detection of the “open head” 4. 3. 11.
position
If an old type of closed head is used, the power source starts to strike an arc provided that the head is in the
“open head” position. If this is not so it will not start the cycle.
If there is any doubt make a test. No damage will occur.
With the various detection functions not operating, the operator has to pay more attention.