6.2.1. Numbers Tab
This tab allows the user to program the Micro Commander with the numbers they wish the Micro
Commander to communicate with and listen to. The FIRST number in the list is defined as the
ADMINISTRATOR number. Only the Administrator may send configuration SMS messages to the
device.
Please Note:
The user should adjust the sliding bar at the bottom of the screen to reserve space
for numbers to be added/removed via SMS.
(See sec 7.6)
6.2.2. Messages Tab
This tab allows the user to program the Micro Commander with the messages they wish the Micro
Commander to respond to and respond with either via SMS, serial port or GPRS*.
6.2.3. Behaviour Statements Tab
This tab allows the user to program the Micro Commander with a number of trigger conditions.
(See chapter 8)
6.2.4. Settings Tab
This tab allows the user to configure the following:
➢
Network Service and GPRS Settings
➢
Enable/Disable Simcard Pin
➢
Enable/Disable Periodic Automatic GSM Reset
➢
Show Debug Comms
➢
Manually send an SMS via the Micro Commander
➢
Write Recipient and IO Names to device
➢
Change application size (pixel dimensions of software)
6.2.5. IO Names Tab
This tab allows the user to rename the input and output to something that means a little more.
Please Note:
These IO Name changes will be stored in the setup that is saved to file, but will
ONLY
be stored in the setup that is saved to the Micro Commander if enabled under Settings Tab.
6.2.6. Lock Setup
This tab allows the user to password protect tabs from being accessed as well as the option to save
a new setup to the Micro Commander. This feature comes in handy when an installer doesn't want
the end-user to be able to make changes under certain tabs
.
© Polygon Technologies. All rights reserved
Page 17
