7.6. Remove a Number from the list
This command can only be sent from the administrator number. To remove a number
(+27831234567) from the list, the administrator must send:
ADMIN REMN 0831234567
The Micro Commander will reply with a confirmation message.
7.7. Enable/Disable statements
This command can only be sent from the administrator number. To enable or disable a specific
statement in the setup on the Micro Commander, the administrator must send:
ADMIN STATEMENT 8 ON
or
ADMIN STATEMENT 8 OFF
This will either enable(
ON
) or disable(
OFF
) statement 8 respectively. The Micro Commander will
reply with a confirmation message.
7.8. Override GPRS Settings
This set of commands allows you to override the GPRS settings that the Micro Commander may have
been configured with and can only be sent from the administrator number. These override settings
are non-volatile, which means their effect will remain after power has been cycled.
To configure the Micro Commander to connect to server via a South African network you must send:
ADMIN GPRSSETUP.PRODUCTION
To turn off GPRS functionality you must send:
ADMIN GPRSSETUP.OFF
To disable any override, and go back to whatever settings were specified by the configuration, you
must send:
ADMIN GPRSSETUP.SETUP
If you need to specify the username and password of your APN(Access Point Network) you must send:
ADMIN SETSERVER: "<apn>" "<username>" "<password>" "UCGPBUPGVQZG"
The Micro Commander will reply with a confirmation message for each of the above.
7.9. Reset GPRS
This command can only be sent from the administrator number. To re-open GPRS you must send:
RESET GPRS
The Micro Commander will reply with a confirmation message.
© Polygon Technologies. All rights reserved
Page 20
