LECOASPIRA 715 - 715 KIT - 725
62
E
E
N
N
G
G
L
L
I
I
S
S
H
H
on the upstroke, then release button (
X
) (so no
steam) for the backstroke, so reclosing the fi-
bres, preventing oversteaming and wetness.
DRY IRONING
• FOR DRY IRONING ONLY (NOT steam iro-
ning), press the main switch (
1
) and adjust
the temperature of the iron by turning dial (
Y
)
to the temperature required for the fabric (as
shown on the dial).
NOTE:
using the iron, it is advisable to adjust
the steam jet at a medium range, or to do some
testing in order to find the jet which is more
suitable to the fabric to be ironed.
IMPORTANT NOTE
• Do not leave the iron unattended whilst con-
nected to the mains.
• Iron only on heat resistant surfaces and on
surfaces that allow the steam to escape e.g.
mesh ironing boards.
• In case of accidental fall of the appliance it is
necessary to have it checked by an author-
ized service center as the internal safety fea-
tures may have been affected.
•
ATTENTION: if you iron sitting down, do not
place your legs under the ironing board, the
steam can cause burns.
G
G
E
E
N
N
E
E
R
R
A
A
L
L
M
M
A
A
I
I
N
N
T
T
E
E
N
N
A
A
N
N
C
C
E
E
Before carrying out any type of maintenance
make sure that the power cable has been dis-
connected from the mains.
After using the brushes it is advisable to allow
the bristles to cool in their natural position so
as to avoid them getting deformed in any way.
Check the conditions of the gaskets located in-
side the monobloc plug (
B2
) periodically.
If necessary, replace them with the appropriate
spares. Also carry out the same check on the
gaskets for connecting the extension tubes (
D
)
and the handle (
A2
).
To clean the outside of the appliance, just use
a damp cloth. Do not use solvents or deter-
gents as these might damage the plastic sur-
face.
To clean the “ECOACTIVE-FILTER” holder and
clean or change the sponge filter, follow the in-
structions in the paragraph headed “EMPTY-
ING AND CLEANING THE DIRT CON-
TAINER”.
W
W
A
A
S
S
H
H
A
A
B
B
L
L
E
E
H
H
E
E
P
P
A
A
F
F
I
I
L
L
T
T
E
E
R
R
WARNING:
Vaporetto Lecoaspira is equipped
with a washable filter. To clean the filter, pro-
ceed as follows:
• Unfasten the handle (
22
) of the dirt container
and remove the container (
20
) as described
in the paragraph headed “PREPARING THE
APPLIANCE FOR USE”.
• Lift the Hepa filter release lever (
18
) and re-
move the filter from its recess (Fig. 14).
• Rinse the filter in cold running water. Shake it
gently after washing to eliminate any residual
dirt and excess water.
NOTE:
let the filter dry naturally, far away
from light and heat sources. You should wait
24 hours before reassembling the filter in the
appliance.
• Replace the filter if it is torn.
• The filter should be cleaned every 4 months.
• To correctly position the Hepa filter (
17
)
make sure that it fits properly into its recess
(
19
) and then that the release lever closes
over it holding it in place (
18
) (Fig.14).
WARNING:
• Do not clean the filter with the brush, as this
could damage it, decreasing its filtering ca-
pacity.
• Do not use detergents, do not scrape filter,
and do not attempt to wash it in a dish-
washer.
LECOASPIRA 715-725 - M0S09202 - 1Q03:Layout 1
23/03/2010
11.50
Pagina 62
Summary of Contents for VAPORETTO LECOASPIRA 715
Page 1: ......
