16. FRESCOVAPOR
only for model
Smart_Airplus
FrescoVapor is a air freshener that contains
natural substances. When mixed with steam it
releases a fresh perfume in every space and,
thanks to its special composition, it is able to
eliminate bad odours.
To use FrescoVapor, proceed as follows:
- Unscrew the cap (19) of the deodorant re-
servoir of the steam gun and fill it with Fre-
scoVapor (20).
- Screw on the cap.
- To adjust the quantity of deodorant, use the
adjustment (21),
to reduce,
to increa-
se. FrescoVapor can be used combined with
the steam to clean all surfaces and with all the
accessories, as described in the paragraph
“Preparing for use”.
Contents: 200 ml
FrescoVapor is on sale at household applian-
ce stores, at Polti authorised service centres
or on the site www.polti.com.
WARNING:
if pressing the steam lever when
the appliance is still pressurised, even if off
and disconnected from the mains, steam
may in any case be released from the flexi-
ble hose. As such, before turning the ap-
pliance off and putting it away, please first
press the lever until the steam flow ceases.
WARNING: Never put FrescoVapor in the
boiler. Only use water in the boiler, following
the instructions listed in the chapter 1.
By increasing the quantity of deodorant, the
surface will be slightly damper, since Fresco-
Vapor mixes with the steam being dispen-
sed. To avoid dispensing FrescoVapor, turn
the adjustment completely forward ( OFF).
The adjustment only determines the quan-
tity of deodorant that mixes with the steam.
It does not regulate the quantity of steam.
To adjust the quantity of steam, you must
use the steam-adjustment dial (8).
WARNING:
- Keep out of the reach of children.
- IF SWALLOWED: Rinse mouth DO NOT in
duce vomiting.
Immediately contact a POISON CENTRE or
a doctor.
- Avoid contact with eyes, skin or clothing.
- Avoid releasing into the environment.
- Dispose of in conformity with local
regulations.
WARNING: Before using FrescoVapor on
upholstery, leather, special fabrics and
wood surfaces, consult the manufacturer’s
instructions and always carry out a test on a
hidden part or sample of the material. Allow
the steamed part to dry to make sure that
no changes in colour or deformations have
occurred.
E
N
G
LI
S
H
| 32 |
VT SMART AIRPLUS-SMART30 - M0S11270 - 1P07:FEV 1000-950.qxd
31/07/2015
17.03
Pagina 32
Summary of Contents for SMART AIRPLUS
