41
MANA DT SMA
POLITEC | INSTALLATION MANUAL - VER.3.1
By default the barriers with 3 or 2 IR beams in combination with the MW pair are set during the
factory testing phase.If it is necessary to change the original number of Beams in the field, DIP
SWITCH 6 or 7 must be set to ON on the 12 unit of the MES9012 motherboard, as shown below:
25.1 Setting of models with 3 Beams
The DIP SWITCH setting on the optics in the column is set as follows:
ON
RX3
ON
RX2
ON
TX2
ON
TX3
ON
RX4
ON
TX4
1 2 3 4 5 6 7
1 2 3 4 5 6
1 2 3 4 5 6 7
1 2 3 4 5 6
25.2 Setting of models with 2 Beams
The DIP SWITCH setting on the optics in the column is set as follows:
Set to ON DIP 7 of the 12 unit on the MES9012 motherboard Receivers side to exclude RX1
Set to ON DIP 6 of the 12 unit on the MES9012 motherboard Receivers side to exclude RX1 + RX2
25.Appendix E: 3TX and 3RX or 2TX and 2RX configuration
1
2 3 4 5 6 7 8 9 10 11 12
ON
1
2 3 4 5 6 7 8 9 10 11 12
ON
ON
RX3
ON
TX3
ON
RX4
ON
TX4
1 2 3 4 5 6 7
1 2 3 4 5 6
1 2 3 4 5 6 7
1 2 3 4 5 6