Politec S.r.l. | Manual Ales – Ver. 1.7.2
5
2.
INSTALLATION TIPS
For proper installation of the product is necessary to remove all possible obstacles between the transmitter and
receiver (trees, grass, etc..), use for the installation immovable poles or walls firmly anchored to the ground.
You should also always use cables with screen for alarm connections, proper sizing by taking more precautions
due to electronic devices.
To avoid interfering with the performance and the degree of protection (IP) of the barrier is necessary to take
the necessary precaution, taking care not to alter seals, plastic and mechanical parts of the product, using
original accessories.
In case of repairs covered by warranty (2 years) but with obvious signs of improper installation, the Politec s.r.l.
reserves the right to decide on any repair costs.
Avoid installing the receivers beams in a position where direct sunlight, at the same angle as the receivers
beams, can enter directly into optics especially at sunset and sunrise
3. INSTALLATION
The barrier ALES can be installed to the wall using the mounting plate and the pole using the mounting plate
and the "U" bracket (Pole
48-50).
WALL MOUNTING
1.
Insert the cable alarm screen in the hole of the plate and fix to the wall with screws.
2.
Pass the cable through the gasket in the base and anchor on the same plate. Make connections to the
terminal.
3.
Following the calibration and verification of proper operation of the system, replace the IR Cover.
