Politec S.r.l. | Manual Ales – Ver. 1.7.2
10
3.
Align the optics placed in the column TX to RX, vertically and horizontally by turning the adjustment
screws (horizontal and vertical) to find the maximum alignment. The condition of maximum alignment will
be achieved when the LEDs are fixed and the buzzer will sound continuously. The condition of partial or
total misalignment is indicated by flashing LEDs and low frequency whistle of buzzer.
► Buzzer sounds continuously for max 3 minutes
To get a good alignment is necessary to make a complete rotation on the optics receiver
horizontal axis, thus effecting the SCANNING of the optical signal.
4.
After obtained the calibration tighten the screw for horizontal adjustment, and exit from TEST mode by
pressing the TEST button for 3 seconds on RX mother board. Two beeps of buzzer will indicate the end of
the TEST function.
►
After adjusting for the next 3 minutes each alarm event will be highlighted by a beeper
1.Vertical adjustment
2. Horizontal adjustment
