PS-3185SH
Installation Guide
P. 17
d.
To decrease the pulse by 10 ms, press the
TRUNK
button.
5.
To save the new settings: press
LOCK
and
UNLOCK
. If 3 honks are returned the new
settings have been saved.
Table 9: Adjusting Honk Duration
Otherwise close the Hood to cancel the changes.
For each timing change, the Horn will honk with the new settings, except in the
following cases:
•
When the lower limit of 5 ms is reached, there will be a 1/4-sec. honk.
•
When the upper limit of 200 ms is reached, there will be a 3/4-sec. honk.
A system reset will set the Remote Car Starter back to the default values: 30 ms.
Testing
Before putting back the vehicle together, it is recommended to check that the system operates
properly. The following testing procedures should be used to verify proper installation and
operation of the system. Before testing, make sure that all connections are soldered and that the
unit is plugged in.
Make sure the Remote Car Starter properly
enters and exits Ready Mode
:
Setting the system to Ready Mode
1.
Ensure that all the Doors are closed and that the Gear Shift Lever is in the
NEUTRAL
position.
2.
With the Engine already running, apply the Parking Brake and release the Brake
Pedal.
Make sure to release the Brake Pedal.
3.
Within 20 sec. push
LOCK
,
UNLOCK
or
START
on the Transmitter.
The Parking Lights will flash 3 times quickly and remain lit.
4.
Remove the key: the Engine will go on running.
5.
Exit the vehicle and close the Door.
6.
Press and hold either:
a.
LOCK
to lock the Doors and shut down the Engine or enter Turbo Mode ;
b.
UNLOCK
to unlock the Doors and shut down the Engine or enter Turbo Mode ;
c.
STOP
to shut down the Engine without affecting the Doors.
Table 7: entering Ready Mode
Remaining in ready Mode
Once the vehicle is in Ready Mode, you can start and stop the vehicle at wish.
However, should any one of the following occur, the vehicle will exit Ready Mode, thus
disabling remote start capabilities until Ready Mode is restored:
•
Door opened,
•
Hood opened,
•
Brake pedal pressed,
•
Parking Brake disengaged,
•
Ignition Key turned to the
IGNITION ON (IGNITION ON / RUN)
position.
Should any of the above occur, Ready Mode will be cancelled.
Table 8: remaining in Ready Mode