P. 8
Installation
Guide
PS-3185SH
9
PURPLE
(–) External
Trigger
The External Trigger wire can be used for remote-
starting the vehicle with an external device. When
the vehicle is running, triggering this input will
activate Idle Mode. The External Trigger wire can
also be used to operate as a negative trigger with the
Trunk Pin-switch, the Key Sense wire or the Door
Pin-switch:
Option 1
Connects to Negative Trunk Pin. When this
wire is programmed for trunk
pin, pressing trunk will
activate a 1-second disarm output. If ground (-) is
detected on the trunk PIN (the Trunk has been
opened), an arm pulse will be sent 5 seconds after
the Trunk is closes. An arm pulse will be sent 4
seconds after the trunk button is pressed if the Trunk
pin state is unchanged (The Trunk was unopened).
Disarm is sent only if the system was previously
locked and armed. If Secure Lock is enabled,
UNLOCK pulse(s) will be sent with disarm, a lock
pulse and a rearm pulse will be sent when the Trunk
is closed or if the Trunk was left closed.
Option 2
(Default: Engine Start/Stop): The first
Ground (-) pulse on this input will start the Engine,
the second Ground (-) pulse on this input will stop
the Engine.
Option 3
(Key Sense (-) Input): Connects to OEM
Key Sense Wire. When the Key is detected in the
Ignition Switch (Ground (-) signal on the OEM Key
Sense Wire) the Starter Kill will not
ARM
even when
it is set to Passive Mode. If Secure Lock is
programmed,
LOCK
and
ARM
will not be activated
while the Key Sense input is active (“active” meaning
there is a key in the Ignition barrel).
10
WHITE
(–) Ground Out
When Running
This wire provides a constant 500 mA ground output
while the Remote Car Starter is running. This output
becomes active at the same time as the Ignition and
shuts off when the Remote Car Starter shuts down,
e.g.: when the Run Time has expired, when the
STOP
button has been pressed, etc. This output
can be used to activate external relays, bypass kits,
etc..
