Polaris Ranger 4X4, Owner'S Manual

Page: 31 / 124

27
FEATURES AND CONTROLS
Seat Belts
Seat Belt Inspection
Inspect all seat belts for proper operation before each use of the vehicle.
1. Push the latch plate into the buckle until it clicks. The latch plate
must slide smoothly into the buckle. A click indicates that it's
securely latched.
2. Push the red release latch in the middle of the buckle to make sure it
releases freely.
3. Pull each seat belt completely out and inspect the full length for any
damage, including cuts, wear, fraying or stiffness. If any damage is
found, or if the seat belt does not operate properly, have the seat belt
system checked and/or replaced by an authorized Polaris dealer.
4. To clean dirt or debris from the seat belts, sponge the straps with
mild soap and water. Do not use bleach, dye or household deter-
gents.
Seat Removal
Pull up on the front of the seat and slide it toward the front of the vehi-
cle.
Install the seat by sliding the tabs into the rear of the seat base. Push
down firmly on the front of the seat until the pins are fully seated into
the grommets.
Fuel Cap
The fuel tank filler cap is
located on the right-hand side
of the vehicle near the passen-
ger seat. When refueling,
always use either leaded or
unleaded gasoline with a mini-
mum pump octane number of
87 R+M/2 octane. Do not use
fuel with ethanol content
greater than 10 percent, such
as E-85 fuel.