2.24
9924874 R02 - 2014
RZR
XP / XP 4 1000 Service Manual
© Copyright 2013 Polaris Industries Inc.
Coolant Level Inspection
The pressure cap (Item 1) and recovery bottle (Item 2)
are located under the front hood of the vehicle. The
coolant level must be maintained between the minimum
and maximum levels indicated on the recovery bottle.
With the engine at operating temperature, the coolant
level should be between the upper and lower marks on
the coolant recovery bottle. If not, perform the following
procedure:
1.
Position the vehicle on a level surface.
2.
Remove the front hood.
3.
View the coolant level in the recovery bottle.
4.
If the coolant level is below the MIN line, inspect the
coolant level in the radiator.
NOTE: If overheating is evident, allow system to
cool completely and check coolant level in the
radiator and inspect for signs of trapped air in
system.
WARNING
Never remove the pressure cap when the engine is
warm or hot. Escaping steam can cause severe burns.
The engine must be cool before removing the pressure
cap.
5.
Remove the pressure cap. Using a funnel, add
coolant to the top of the filler neck.
6.
Reinstall the pressure cap.
NOTE: Use of a non-standard pressure cap will
not allow the recovery system to function
properly.
7.
Remove recovery bottle cap and add coolant using a
funnel.
8.
Fill recovery bottle to MAX level with recommended
coolant or 50/50 or 60/40 mixture of antifreeze and
distilled water as required for freeze protection in
your area.
Recommended Coolant:
Polaris Premium Pre-Mixed Antifreeze
PN 2871534 (Quart)
PN 2871323 (Gallon)
9.
Reinstall the recovery bottle cap.
10. If coolant was required, start engine and check for
leaks. Make sure radiator fins are clean to prevent
overheating.
MAINTENANCE
Summary of Contents for 2014 RZR XP 1000
Page 5: ......
Page 472: ...HARNESS CHASSIS RZR XP 1000 ...
Page 473: ...HARNESS CHASSIS RZR XP 1000 ...
Page 474: ...HARNESS BOX RZR XP 1000 ...