Figure 43
Figure 44
5. To access the valve, use a flathead screwdriver to remove the small brass screw located in the
center of the underside of the receiver (#26). See Figure 43. To remove the valve body, use a
flat ended wooden dowel or the eraser end of a pencil to push the valve body out of the front
of the receiver. See Figure 44.
VALVE REMOVAL CONTINUED
pure energy vertical regulator
DSR REGULATOR
Questions about the operation of the PMI Piranha
®
paintball marker may be directed to: Pursuit Marketing,
Inc., 55 Howard Ave, Des Plaines, IL 60018 USA; phone 1.800.579.1633 or www.buypmi.com for any updates
regarding your Piranha
®
purchase.
6. The valve body must be inserted correctly with the raised flat surface of the valve and larger hole pointing
towards the front of the marker. Be careful reinserting the valve body. Any scratches to the front can cause
leaks. Use a flat ended wooden dowel or the eraser end of a pencil to push the valve body into the front
of the receiver. See Figure 45. The valve pin assembly must be inserted correctly into the valve; valve pin
must drop down into valve body completely.
39
40
3
2
4
1
6
9
14
13
3
8
6
6
11
16
15
7
5
10
12
17
1.
Bottle O-Ring
41010
2.
NGO Top
41600
3.
Reg Seat Seal
41517
4.
Poppet O-Ring (013-70)
57976
5.
Poppet
41509
6.
Reg Seat Base O-Ring (006-700)
10162
7.
Spring
41510
8.
Reg Seat Base
41505
9.
Reg Body Mid (black)
41601
10.
Bottom Swivel (black)
41602
11.
Bottom Bolt O-Ring (012-70)
18085
12.
Bottom Bolt
41503
13.
Adjusting Screw
41504
14.
Adjusting Screw O-Ring
57607
15.
DSR 14-32 Plug
41506
16.
Seal Stop O-Ring (002-70)
57631
17.
Interior Bottom Bolt O-Ring (010-70)
57645
Figure 45
The EXT comes standard with the DSR Regulator which can directly affect velocity. Most EXT markers will shoot 280 fps with
the regulator set at 300 psi. Turning the pressure up with a 3/32” allen key should raise velocity. To turn the pressure up,
turn the bottom adjustment screw counterclockwise (looking at the bottom of the DSR) with a 3/32” allen wrench.
Marker must be fired several times for regulator to accept new setting.
NOTE:
Make sure marker is un-cocked before continuing to step 4.
4. To remove trigger frame from the receiver, remove the two 1/8” socket allen screws (#29) under
the receiver. One is in front of the trigger guard and one is behind the grip portion of the
frame. See Figure 42. The receiver then will disassemble from the trigger frame.
IMPORTANT: Valve body O-rings and front valve portion of the receiver
must be well oiled prior to valve body insertion.
