TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 23
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
2.4 miniWIPERConcatenate
Begin the program operation by clicking “miniWIPERConcatenate.jar”. The program presents the
screen shown below.
The miniWIPERConcatenate program
reads and concatenates the files recorded
by the miniWIPER. This program
produces a CAT.txt file in the same folder
as selected for the data. The CAT.txt file
contains all the original measurements
and contains two additional statements of
time.
Select the folder that contains the files recorded by the miniWIPER. If the miniWIPERPlot program is
run directly from the miniWIPER, then the program will suggest the folder located on the
miniWIPER.
You may accept this by clicking “Concatenate”, or you may click “Select DATA Folder”
to browse your HOST
computer’s hard drive. If the number of measurements recorded is small, for
example a few thousand, then these can conveniently be plotted directly from the miniWIPER
Logger’s storage. However, it is best to copy large measurement sets to the HOSTcomputer and
select them there. The file access to the miniWIPER is slow.
The miniWIPER measurement folders must NOT contain any files besides those the miniWIPER
recorded and the CAT.txt file.
Click “Concatenate” to begin concatenating files and create the CAT.txt file.
The CAT.txt file will resemble the following:
End the miniWIPERConcatenate program by closing the window.
