Pluto CIRCLE 0, Instruction Manual

Page: 11 / 14

Assembly method
Assemble the motor cover (top)
so that the motor cover
(bottom) protrusion is visible.
Set inside properly leaving no gap A gaping condition
Bumper on the motor
cover(bottom) is hidden
in the motor cover (top).
Install the motor cover(top). Make sure that the motor cover is properly fitted
to the bumper of the motor cover (bottom). Press the waste bin correctly.
Failure to do so may cause the 3 LED
sensors to turn on and not operate.
Waste bin
Outer shell Cover
(Top)
Install the outer shell cover(top).
Make sure that the four pins on the left
and right sides are tight and that there
are no gaps in the back. Assembly complete. Check that the scoops are correctly located and that the
cat litter is aligned with the fill line(The line is marked inside litter box).
Plug in the power cord and use.
Check the scoop is in place (at 1 O'clock).
What if there is a gap in the outer shell cover and it won't close properly even though the pin position is
correctly assembled?
If the litter box is out of position, the outer shell cover will not close completely.
Please make sure that there are no gaps around the entrance of the litter box and reassemble if there are
any gaps. (Step 8)
What's the problem with the slide door not closing completely or sounding?
Please make sure that there is no gap between the pins and ribs when connecting the litter box.
In particular, please make sure that the ribs on the back of the litter box be properly fitted. (Step 6)
The scoop is in a strange position. What should I do?
Make sure the positioning sensor is assembled in the correct position. (Steps 1 to 2)
Please make sure that the litter box and scoop are installed in the correct direction. (Steps 3 to 5)
When connecting the motor shaft connection to the shaft, make sure that the letter "UP" is facing up.
(Step 9)
Frequently Asked Questions