Pluto CIRCLE 0, Instruction Manual

Page: 12 / 14

This is not a malfunction
These are some of the most frequently asked questions. Please read them if you are experiencing troubles.
The scoop is still and stops moving. Is it broken?
If the sensor responds during operation, it stops working, but starts moving again after 7 minutes.
In addition to the cat's bowel activity, the sensor often detects the head and tail, which can delay cleaning.
The cat litter has a strong resistance that prevents the scoop from draining it.
Immediately turn off the power and reduce the amount of cat litter below the appropriate fill line.
There's too much loss of sand. Isn't that bad?
Depending on the type and shape of the cat litter, extra cat litter may be discharged. Reducing the amount of cat litter
to align with the cat litter line may reduce the amount of discharge.
Using cat litter that is not suitable for the scoop type (bentonite only, tofu litter only) will result in cat litter being drained
out of the scoop. Pay attention to the scoop type and use suitable cat litter. (page 3)
What if it doesn't start working even after 7 minutes the cat has voided excrement?
If the sensor responds during the 7 minute count, the 7 minute countdown starts again from that point.
When the bowel is full, the sensor reacts and does not operate. In this case, the three LED lamps light are on, so make
sure the drain is empty.
The litter box wasn't properly fitted. Or the motor shaft connection and shaft are not properly connected. Please check.
(Step 6-9 on page 9)
The waste bin is empty, but there are three lights on. Is it broken?
The waste bin is not properly installed. Push it perfectly. Or, check if you used a transparent plastic bag and check if it
was covered properly.
It's seven minutes from the moment it's turned on. Is the sensor broken?
If the litter box is not properly installed.(Step 2 on page 4)
Or, at the moment you plug in the power cord, you may have touched the location of sensor.
Is it sensor error when the 3 LED lamps lihgting are on even though the sensor is switched off?
Even if the sensor is turned off, the 3 LED lamps will light when the waste bin is full, but the scoop will operate normally
without stopping. The sensor button stops working when the waste bin is full, which is not related to the LED lamps.
(Mode for long-term outings to operate even if the waste bin are full)
※ When the sensor is on, the three LED lamps light and the scoops will not operate when the waste bin are full.
(See Additional Description on page 7)
Is there an error when the 3 LED lamps are lit sequentially?
If the amount of cat litter is added in excess of the proper amount, it can be caused by overload during operation.
If the litter box to the motor is incorrectly connected, the three LED lamps will light sequentially and will not operate.
(Step 8-10 on page 9)
Check point
If the location of the scoop is strange, do you need to reassemble it?
The directional shaft and scoop of the motor shaft coupling, the position of the scoop when connecting the shaft, and if
all of these are not installed correctly, the scoop cannot be correctly located. See how to assemble on page 9.