Pluto CIRCLE 0, Instruction Manual

Page: 10 / 14

Assembly method
Be careful when stopping components in the wrong position, as it may not function correctly or cause failure.
Be sure to remove the power cord after you have checked the product has completely stopped working.
Assembly
Motor shaft connection
Position sensor
The positioning sensor
is facing down.
First check the position of the motor shaft
connections. If the positioning sensor is
facing directly down, it is in the normal
position.
※ Unplug the power cord when stopping in position
If the position sensor is not in position or
unknown, disconnect and reconnect the
power cord. It will move to the normal
positon and stop itself.
※ A look from above
The word "UP" is facing upwards.
Check the position of shaft. Make sure
that the letter "UP" is facing up.
※ Check if spring is in.
Scoop
Make sure that the shaft contains a
spring, install the scoop and rotate the
screw cap to secure it.
※ Attention to hexagonal holes.
If the triangle of the scoop and the
triangle inside the litter box are facing
each other, the assembly is correct. Install litter box lid to fit the lib. Make
sure that the 6 pins on the left and right
sides are properly secured before closing
them.
Buckle
Litter box
Close the buckle. Make sure there are
no gaps in the lid and bottom joints
of the litter box. Place the litter box in the bottom of the
product. Make sure there are no gaps,
such as around the entrance. Make sure that the letter "UP" on the shaft
is facing upwards. Move the shaft in the
direction of the arrow to connect the shaft
to the motor shaft connection.
Lib
Pin
Screw cap
Shaft
Motor shaft
connection
Back of litter box
Back of Litter box
Motor cover(Bottom)