Putting the panel away
Carefully clean the panel’s surface before putting the panel away. If this is not done, dust or
dirt could get on the panel’s back surface when the panel is rolled up, reducing magnetic
effect.
Roll up the panel.
Roll the holding bar onto the paper tube used in the package, then roll up carefully, pressing the
holding bar against the board surface and being careful that there is no looseness in the roll and
that the roll does not get crooked.
NOTE
• When rolling up the panel, apply enough pressure to keep the panel from falling away from the
surface on which it is mounted. If you release the panel in the middle of the rolling up process,
the panel will fall.
• Do not roll too tightly. Doing so could cause creases in
the panel surface or cause the panel to curl.
• Attempting to correct for crookedness by force while the panel is partially rolled up on the hold-
ing bar could damage the panel. If there is any skewing, unroll the panel completely then start
over.
• Do not remove the panel from the surface upon which it is mounted with the panel unrolled.
Doing so will cause the panel to crease, making it impossible for the digital pen to be read and
resulting in malfunction.
• Be careful not to cut your hands when touching the edges of the panel.
Paper tube
[Correct]
[Incorrect]
Holding bar
