UNUM VEP4600 Appliance - Getting Started Guide - Copyright © 2020 by Pluribus Networks. All Rights Reserved.
Page 41 of 60
UNUM VEP 4600 Configuration (cont'd)
Configuration Steps for VEP
ESXi Configuration
:
1.
Create a
Vswitch
on the
ESXi
host with the following settings:
a)
promiscuous mode enabled
b)
allow forged transmits
2.
Portgroup is created (with optional VLAN parameter; defaults to 0 (untagged))
3.
Assign a vnic to the vswitch. This vnic is the physical port connected to the switch and needs to be
entered correctly by the user for configuration to succeed. Without this is the physical link, the vNV
cannot find the fabric to join.
vNV Configuration
:
1.
vNVss Ne otek dcp ee 3 cssigoed t tis pte getop.
2.
vdata0 interface on vNV needs an IP address configured in the same network as the inband IP address of
the switch.
3.
vNV should have web-enabled on data using:
admin-service-show if mgmt web
(same as the
management scenario).
