![background image](http://html.mh-extra.com/html/plum/ecomax850p1-a/ecomax850p1-a_user-manual_1568473013.webp)
13
By boiler operation configuration with the
buffer decrease of top buffer temperature
below preset value (
Temperature when
start buffer feeding
).
8.10
GRID
Some boilers have an additional grate to
burn other fuels such as wood waste, etc. To
activate the grid, move the parameters
available in the:
Main menu
→
Boiler settings
→
Boiler
oper. mode
from "pellet" to "grid". In the grid mode fuel
feeder is turned off. The combustion process
is regulated by the fan. Fan power, when
working with grid, is set in:
Main menu
→
Boiler settings
→
Output
modulation > Fan power – grid
The values of parameters such as:
Main menu
→
Boiler settings
→
Prest
boiler temp
Main menu
→
Boiler settings
→
Output
modulation
→
Boiler histeresis
Main menu
→
Service settings
→
Burner
settings
→
Fuel detection time
are individually adjusted for the "grid". This
allows you to define different properties of
boiler operation for operation modes "grid"
and "pellets".
When using the grid an alarm "No fuel" can
appear. This alarm occurs when a
temperature drops below the value of the
parameter:
Main menu
→
Service settings > CH and
HUW settings
→
CH activation temp.
and then for a period of 10 minutes there
has been no growth.
8.11
HOT WATER SETTINGS
The controller regulates temperature of the
silo of Hot Water HW, providing that the
temperature sensor is connected. When the
sensor is disconnected – the information
about it is displayed in the main window. By
selecting:
Menu
→
HUW settings
→
HUW Pump
mode
the user is able to:
Deactivate feeding the silo, parameter
Deactivated
,
Setting HW priority, by parameter
Priority
–
then
CH
pump
is
deactivated to feed the HW boiler
quicker,
Set simultaneous operation of CH and
HW pump with the parameter
No
priority
,
Activate function
Summer
.
8.12
HOT WATER TEMPERATURE
SETTINGS
Preset temperature HW is defined by
parameter:
Menu
→
HUW settings
→
Preset HUW
temperature
8.13
HYSTERESIS OF HOT WATER
FEEDER
Below temperature
Preset temperature HW
–
Silo hysteresis HW
the HW pump will activate
to feed the HW silo .
By small hysteresis value HW pump
will activate faster after HW
temperature decrease.
8.14
SUMMER FUNCTION START UP
To activate SUMMER function which allows
feeding the silo during summer, without
necessity to activate CH installation and
mixers periods, it is required to set the
Pump
operation mode HW
for
Summer
.
Attention: when boiler operates
without heating buffer and the
controller is switched into SUMMER
mode,
than
Standard
mode
operation is is recommended. point
8.6
It is not allowed to activate
function summer when HW pump is
disconnected or damaged.
Function
SUMMER
can
be
activated
automatically, on the basis of readings from
weather sensor. Use following parameters to
activate this function:
Menu
→
HUW settings
→
Auto. detection
SUMMER, Activating temp. SUMMER,
Deactivating temp. SUMMER
Summary of Contents for ecoMAX850P1-A
