![background image](http://html.mh-extra.com/html/plum/ecomax850p1-a/ecomax850p1-a_user-manual_1568473035.webp)
35
Air flush stop
Flame brightness with which airflow starts when burning off the fuel in
burning off process
Cleaning
Poker p. before inflame
Fan operation time during cleaning the furnace while firing up
Poker p. after bur.off
Fan operation time during furnace burning off
Cleaning airflow
Fan power in % during furnace cleaning in burning off and firing up
Supervision
Supervision time
After this time, when the controller is in SUPERVISION mode, the
controller automatically starts burner burning off. By settings = 0,
SUPERVISION mode is deactivated.
Feed time
Fuel feeding in SUPERVISION mode. It has influence on burner power
by operating in SUPERVISION mode. Attention: the value should be as
small as possible, just to keep the flame burning. Too big value may
cause to boiler overheating.
Cycle time
Feeder operation time in SUPERVISION mode.
Supervision cycle time
=
Supervision feeding time
+ feeder pause time in Supervision..
Blow-in output
Fan power in % during operation in Supervision mode. Adjust value in
such a way to burn feeding fuel in Supervision mode with low fumes
emission.
Grate*
Flush time SUPERVISION
The duration of the fan blow in the supervision in grid mode
Flush period SUPERVISION
Interval between blows in the supervision in grid mode.
Min. airflow output
Minimum fan power in % which can be chosen by the user. It is only
used to limit the accessible scope of fan power. It is not used in
algorithm of controlling the fan. It should be possibly small to allow the
fan to rotate slowly, without buzzing.
Fuel detection time
Time is measured after decrease in brightness of flame below value
flame detection %
. After deducting this time the controller switches into
firing u
p attempt. After 3 failed attempts, it reports alarm: “failed firing up
attempt”
Max. burner temperature
Determines maximum temperature of feeder when there is alarm of
exceeding maximum feeder temperature
Additional feeder operation
time
Determines additional feeder operation time. Feeder is attached to
additional module B. After this time additional feeder operation is
stopped despite disconnecting joints of fuel level sensor. Joints of fuel
level sensor are located in additional module B.
14.2
BOILER SERVICE SETTINGS
Boiler settings
Thermostat selection
Options to choose from:
Deactivated (deactivates room thermostat influence on boiler
operation)
Universal (activates room thermostat for boiler)
ecoSTER200 T1 (option available after connecting room panel
ecoSTER200, boiler operation is dependant on room thermostat
No1 in ecoSTER200)
ecoSTER200 T2 (option available after connecting room panel
ecoSTER200, boiler operation is dependant on room thermostan No
2 in ecoSTER200
– on sensor CT7)
ecoSTER200 T3 (option available after connecting room panel
ecoSTER200, boiler operation is dependant on room thermostat
No3 in ecoSTER200
– on sensor CT7)
Summary of Contents for ecoMAX850P1-A
