15
BIA AeroFresh Plus
Englis
h
5.1. CONTROL UNIT
1
On/off switch
2
Display
3
LED corresponding to the SELECT button
The LED flashes when the SELECT button must be
pressed.
4
SELECT button
You can choose between different functions in a pro-
gramme.
5
LED corresponding to the SET button
The LED flashes when the SET button must be pressed.
6
SET button
Values can be set.
7
DIP switch
The DIP switches are already correctly set as default and
must not be moved.
8
MODE button
•
Manually rinse steam cylinder
•
Start programmes
5.2. PROGRAMMES
The following programmes can be started using the MODE
button:
•
dISP
(display)
Basic function of the display.
•
SEr
(service)
Functions for the service.
•
AdJ
(Adjustments)
Set parameters.
•
CtrL
(controller)
Enable internal humidity controller.
Set parameters.
•
drA
(drain)
Set special drain functions.
•
Coun
(count)
Display operating hours.
•
rSt
(reset)
Reset settings to factory settings.
•
inFo
(information)
Display software version.
5.2.1.
"Service" programme
The following functions can be started using the SEr pro-
gramme:
•
Display water level in the steam cylinder.
•
Display steam request.
•
Effective heating current in amperes.
•
Manually confirm the components of the humidifier for a
service check.
1. Repeatedly press MODE button until the display shows
SEr
.
2. Press SELECT button.
SE.on
is displayed when the maximum water level is
reached.
SE.oF
is displayed when the maximum water level is
not yet reached.
3. Press SELECT button.
H on
is displayed when steam has been requested.
H oF
displayed when no steam has been requested.
4. Press SELECT button.
0000
displays the effective heating current in amperes.
5. OPERATION
Note:
The entire operation of the control system must only be
carried out by qualified expert personnel.
The user can set the humidity set points in the pro-
gramme
CtrL
if necessary, see page 17.
4
3
6
7
5
8
1
2
M+P-26A-1019
Note:
The display is already set to 40 % for the relative hu-
midity as default.
