Plextor PX-800A, Installation And User Manual

Page: 17 / 94

Section 2. Installing the PX-800A Internal ATAPI Drive
PX-800A Installation and Users Manual
9
•
Eject button : Push once to eject tray. Push again to insert the tray
back into the PX-800A. To prevent wear on the drive, always use the
eject button to insert the tray.
Rear Panel—PX-800A Internal Drive
Also familiarize yourself with the drive’s rear panel.
Figure 2: Rear panel of the PX-800A internal ATAPI drive
•
Digital audio output connector : Outputs a digital stereo signal. Use
this to connect to a sound board that supports Sony/Philips Digital
Interface (SPDIF) or Digital-In.
•
Analog audio output connector : Outputs an analog stereo signal.
Use this to connect to a sound board or audio amplifier. Use a
standard MPC-3 type, 4-pin connector.
•
Mode jumper : Use the mode jumper to select operation as an IDE
master or slave, or for cable select. In general, leave this jumper at
its factory setting, which is master; and ensure that any other device
on the bus is jumpered as slave.