Plextor PX-800A, Installation And User Manual

Page: 75 / 94

Appendix A: PX-800 Specifications
PX-800A Installation and Users Manual
67
Disc Loading Auto
Rear Panel, PX-800A Internal ATAPI Drive
Power Supply DC +12V,
±10% DC +5V,
±5%
Typical standby current 20mA 300 mA
Typical DVD read
current (at max speed) 850 mA 950 mA
Typical CD read current
(at max speed) 900 mA 850 mA
Typical DVD write
current (at max speed)
900 mA 1450 mA
Typical CD write current
(at max speed) 900 mA 1400 mA
Peak current 1000 mA 1500 mA
Rear Panel, PX-800A Internal ATAPI Drive (continued)
Power
Consumption
Peak 19.5W
IDE Interface
Connector IDE bus, 40-pin flat ribbon type. Interface complies
with ATA/ATAPI-5. Must use 80-conductor IDE/ATA
cable.
NOTE : Although the PX-800A will operate with a 40-
conductor cable, it may not be able to write at 18X
unless an 80-conductor IDE/ATA cable is used.
Maximum total cable length cannot exceed 18 in (45.7
cm).
Analog Audio
Output
Connector
ƒ
Stereo analog output, Molex connector (L*G*G*R),
MPC-3 standard
ƒ
Output voltage: 0.75 V ±1.5dB
ƒ
Load impedance: 10k ohms
ƒ
S/N ratio: >80 dB
ƒ
ƒ
Frequency response: 20Hz-20kHz ±3 dB
Digital Audio
Output Digital audio output for input to SPDIF or Digital-In
input