3101 111th Street SW
•
Suite F
•
Everett, WA 98204
425-353-7552
•
plcmultipoint.com
207
L
Re
v1
19
Gateway Commissioning & Start-up Guide
After tapping “Create the First Zone”, a new screen will launch to allow for a
custom zone name to be entered.
Enter the desired name for the zone that you are configuring.
For a zone that requires time-switch functions, you may select the check-box to the left
of “Time-Switched Zone?” For information on the behaviors of time-switched zones,
see the “Time-Switch Zone” section in this document.
For a zone that is intended to respond to Demand Response events, you may select
the check-box to the left of “Demand Response?”
This does not enable Demand Response but indicates if a zone should participate in
Demand Response events if or when Demand Response is enabled for the
gateway. Press “OK’, or, to return to the prior screen, press “Cancel”.
Note: For the examples in this document, the zone name “Example Room” will be used.
Scanning for Light Nodes
The next step is to begin scanning for all available light nodes that are in range and not yet associated with a given network.
Sensors will be paired to a zone during a later step.
Do not power sensors at this point in the process.
Ensure that lights for the targeted zone are in pairing mode (also referred to as discovery mode). All devices should
automatically enter pairing mode upon their initial power-up sequence, though some devices have timeout limitations for
the pairing process. Refer to the specific manufacturer instructions for the devices that you are attempting to discover
in the scanning process.
Tap on “Begin Scan” to start the discovery process.