Models UN5048 & UN5049
PA 1018
Page 11 of 12
Installation Instructions
Fasteners
• Inspect for loose fasteners.
Tightening torque specifi cations are:
Bolts and Nuts: Snug tighten and tighten an additional
one-half turn.
• Inspect drive rivets to insure they are intact and secure.
• If during the maintenance process a bolt needs to be
removed from a part or parts, it will be necessary to apply
a drop of liquid thread lock / loctite to the bolt before
reinstallation.
• Inspect for missing, worn or broken fasteners. If any
missing, worn or broken fasteners are found, refer to the
installation instructions for proper replacement fastener.
If any damage is detected, barricade equipment to
prevent use until repair is completed. Contact your sales
representative immediately for a replacement part.
Plastic Parts
• Inspect all plastic surfaces for sharp points, cracks
or jagged edges. If any damage is detected and is
determined to be unsafe, barricade equipment to prevent
use until repair is completed. Minor burrs or sharp edges
may be removed by using a sharp utility knife or block
plane to remove sharp burr.
Castings
• Inspect the aluminum castings to insure they are properly
secured to the component.
• Visually inspect the castings for cracks or breakage. If
any damage is detected, barricade the equipment to
prevent use until repair is completed. Contact your sales
representative immediately for a replacement part.
Welds
• Inspect all welded joints. If any broken welds are detected,
barricade equipment to prevent use until repair is
completed. Contact your sales representative immediately
for a replacement part.
Equipment Maintenance
Universal Models
UN5048 and UN5049
Tall and Short Drum Kit
Finish
• Inspect metal parts for fi nish damage.
To repair painted surfaces, sand damaged area with
sandpaper and wipe clean. Mask area and paint with
primer and allow to dry. Paint primed area with color-
matching paint and allow to dry. Recoat area with color-
matching paint if required. Drying time is approximately
8 hours between coats.
Footings
• Inspect component to be solid in footing and secure. If
any damage is detected, barricade equipment to prevent
use until repair is completed.
Surfacing
• Refer to the specifi c surfacing maintenance detail sheet
for additional information.
Replacement Parts
• Refer to your installation instructions to obtain replacement
part number.
• Contact your sales representative or call Playworld
Systems’ Customer Service for a replacement part.
1000 Buffalo Road • Lewisburg, PA 17837
www.playworldsystems.com
For Customer Service, Call
800-233-8404 or
570-522-9800
OUTSIDE U.S.