Installation Instructions
Model CH4589
ECN2156
Page 6 of 7
Notes Before You Begin:
Do not over tighten bolts during assembly, only snug
tighten them until assembly is complete.
Carefully read and understand these installation instructions before you
begin.
Step 1:
Before attempting to assemble your equipment, please review all
installation information carefully. Should you experience any diffi culty during the
installation process, please call us at the phone number shown on the last page
of these instructions.
Step 2:
Separate and identify all components and hardware.
Step 3:
Determine location of the panel by referring to the master plan view /
structure layout drawing.
Attach the adaptors to the bells
Step 4:
See
Detail A
. Attach as shown for all (4) four bells. Fully tighten the
connections according to tightening torque specifi cations.
Torque Specifi cations:
Bolts and nuts
- Snug tighten and then tighten an additional one half turn.
Attach the bells to the panel.
Step 5:
See
Detail B
. Ensure the adaptor is fl ush against the panel and aligned.
Attach as shown. Repeat procedure for the remaining bells. Match the bells with
the appropriate sized cutout. Fully tighten the connections.
Note:
The bells should all be attached to the same side of the panel.
Attach the music notes (bell strikers) to the bell panel.
Step 6:
See
Detail C
. Position the music notes on the opposite side of the panel
from where the bell adaptors are mounted and attach as shown.
Attach panel connectors to the panel.
Step 7:
See
Detail D
. Position each panel connector so that the short leg aligns
with the hole in the panel. The short leg of both connectors should point in the
same direction. The connectors must all attach to the side of the panel that faces
away from the deck. Attach as shown. Leave the connections loose for alignment
adjustment.
Attach the clamps to the connectors.
Step 8:
See
Detail E
. Place the fl at side of each clamp against the panel side of
the connector. Apply a of thread locking adhesive to the bolt threads and attach
as shown. Leave the connections loose for alignment adjustment.
Attach the panel to the support posts.
Step 9:
See
Detail F
. Apply a of thread locking adhesive to the bolt threads and
attach as shown. Leave the connections loose for alignment adjustments.
Note:
In the event of a clamp confl ict with an adjacent component, the panel
connector can be fl ipped upside down and reconnected to the panel. Remove the
connector from both the panel and clamp before fl ipping and then reattach as in
Steps 7
and
8
. If possible, both clamps should be mounted at the same height.
Final Details.
Step 10:
Plumb and level the component. Tighten
all
fasteners. Fully tighten all
fasteners according to tightening torque specifi cations.
Torque Specifi cations:
Bolts and nuts
- Snug tighten and then tighten an additional one half turn.
Step 11:
Install drive rivets. See
Detail G
. After the equipment assembly is
complete, install a drive rivet in each clamp to permanently secure it to the support
post. Using a 1/4" drill bit, drill through the clamp and support post. Insert the
drive rivet into drilled hole until the head of the rivet is against the surface of the
clamp. Using a hammer, drive the pin of the rivet until it is fl ush with the surface
of the rivet head.
Note:
This step should be executed after structure has been assembled and
properly footed.