Installation Instructions
Model CH4607
ECN2096
Page 6 of 7
Notes Before You Begin:
Do not over tighten bolts during assembly, only snug
tighten them until assembly is complete.
Carefully read and understand these installation instructions before you
begin.
Step 1:
Before attempting to assemble your equipment, please review all
installation information carefully. Should you experience any diffi culty during the
installation process, please call us at the telephone number shown on the last
page of these instructions.
Step 2:
Separate and identify all components and hardware.
Step 3:
Attach a chime striker to the chime upper caps. See
Detail A
. Insert the
stem of the handle through the front of the cap and seat squarely into the striker,
apply a drop of thread locking adhesive to the bolt threads, and attach as shown.
Fully tighten the connections according to tightening torque specifi cations (See
Final Details
).
Step 4:
Attach the chimes and the chime caps (upper and lower) to the chime
panel. See
Detail B
. Chimes attach to the panel from the shortest to the longest
going from left to right. Attach to the side of the panel that's routed out for the
chime caps. Place the chime spacers and chime supports in their appropriate
cutouts in the panel, place the chimes on top, align the holes and then place the
chime covers over the top and bottom of the chimes, and attach as shown. Fully
tighten the connections according to tightening torque specifi cations (See
Final
Details
).
Step 5:
Secure the chime caps (upper and lower) to the chime panel. See
Detail
C
. Secure the caps to the panel through the remaining open hole in the cap. Fully
tighten the connections according to tightening torque specifi cations (See
Final
Details
).
Step 6:
Attach the panel connectors to the chime panel. See
Detail D
. Position
the short leg of the panel connector over the top outside hole in the panel on the
opposite side from the chimes, and attach as shown.
Step 7:
Attach the clamps to the panel connectors. See
Detail E
. Position the
clamp against the chime side of the panel connector, apply a drop of thread locking
adhesive to the bolt threads, and attach as shown.
Step 8:
Attach the panel to the support posts. See
Detail F
. Position the panel
between the support posts with the bottom of the chime side against the deck.
Close the clamps around the posts, apply a drop of thread locking adhesive to
the bolt threads, and attach as shown.
Note:
In the event of a clamp confl ict with an adjacent component, the connectors
can be fl ipped and reconnected to the panel. Remove the connector from both
the panel and clamp before fl ipping and then reattach as before.
Final Details.
Step 9:
Plumb and level the component. Tighten
all
fasteners. Fully tighten all
fasteners according to tightening torque specifi cations.
Torque Specifi cations:
Bolts and nuts
- Snug tighten and then tighten an additional one half turn.
Step 10:
Install drive rivets. See
Detail G
. After the equipment assembly is
complete, install a drive rivet in each clamp to permanently secure it to the support
post. Using a 1/4" drill bit, drill through the clamp and support post. Insert the
drive rivet into drilled hole until the head of the rivet is against the surface of the
clamp. Using a hammer, drive the pin of the rivet until it is fl ush with the surface
of the rivet head.
Note:
This step should be executed after structure has been assembled and
properly footed.