A
TARP
36" X 117"
TARP
BOARD
CENTER TARP BOARD
DETAIL A
SCALE 1 : 3
1/4" WASHER
#14 X 1-1/4"
PAN HEAD SCREW
GROMMET
STEP 37: TARP
1: LAY THE TARP OVER THE TOP OF THE CENTER TARP BOARD AND MAKE SURE THE HEM
SIDE FACES DOWN.
2: WRAP EACH END OF THE TARP AROUND THE END OF THE TARP BOARDS INTO THE
INSIDE. IT MAY HELP TO HAVE A HELPER ON ONE SIDE WHILE YOU DO THIS SO THAT YOU
CAN MAKE THE ENDS OF THE TARP OVERLAP THE TARP BOARD EVENLY ON EACH END.
3: ONCE BOTH ENDS ARE WRAPPED EVENLY, MARK THE LOCATIONS OF THE GROMMETS
ONTO THE TARP BOARD ON ONE END ONLY. LET THE TARP END HANG DOWN AND DRILL
1/8" HOLES AT THE MARKS 1" DEEP.
4: FASTEN THE END OF THE TARP TO THE TARP BOARD USING THE HOLES YOU DRILLED WITH
#14 X 1-1/4" PAN HEAD SCREWS AND 1/4" WASHERS.
5: GO TO THE OTHER SIDE OF THE TARP AND WRAP THE END AROUND THE TARP BOARD
KEEPING THE TARP TIGHT. MAKE MARKS THROUGH THE GROMMETS ONTO THE TARP
BOARD. LET THE TARP END HANG DOWN AND DRILL 1/8" HOLES AT THE MARKS 1" DEEP.
6: FASTEN THE END OF THE TARP TO THE TARP BOARD USING THE HOLES YOU DRILLED WITH
#14 X 1-1/4" PAN HEAD SCREWS AND 1/4" WASHERS.
62
