4
5
5-1
5-2
5-1
5-2
5
5-1
Assembly Steps
Ø10 Washer
Split pin
Ø10
Washer
Steering column
●
Turn the vehicle body on its side.
●
Remove the screw and nut from the steering column.
●
Slide a
Ø
10 washer onto the steering column from the straight end (PIC 5-1).
●
Insert the straight end of steering column up through the hole in vehicle body and out through
the hole in the dash.
●
Insert the bent end of steering column through the hole in the front axle plate, fit a
Ø
10 washer
onto the steering column and insert a split pin into the hole in the steering column, bend the ends
of split pin back using a pair of pliers (PIC 5-2).
Hubcap
Ø10
Washer
Ø10
washer
Ø10
bushing
Front
axle
Wheel
Ø10
Locknut
●
Remove the parts from the front axle.
●
Fit a
Ø
10 washer onto the axle.
●
Fit a
Ø
10 bushing onto the axle.
●
Fit a wheel onto the axle, make the wheel
match with the bushing.
●
Fit a
Ø
10 washer onto the axle.
●
Tighten the
Ø
10 locknut with a spanner. (Do
not over tighten)
●
Insert the hubcap.
●
Repeat for the other wheel(s).
Direction
gear box
Steering
column
M5x25
Machine screw
●
Turn the vehicle body on its side.
●
Remove the screw and nut from the steering column.
●
Insert the straight end of steering column up through the hole in vehicle body and out through
the hole in the dash.
●
Insert the bent end of steering column through the hole in the front axle plate.
●
Line up the holes in the direction gear box with the hole in the steering column. Tighten the
M5x25 machine screw and
Ø5 nut back in the same location (PIC 5-1).
●
Fit a
Ø
10 washer onto the bent end of the steering column and insert a split pin into the hole in
the steering column, bend the ends of split pin back using a pair of pliers (PIC 5-2).
Ø5 nut
