3
Assembly Steps
2WD
2WD
●
Turn the vehicle body downside up.
●
Remove all the parts from the rear axle.
●
Insert the rear axle through the hole in the
vehicle body.
Rear axle
Hint: An extra spanner has been provided to hold the Ø10 locknut on the other side
of the front axle while tightening the locknut on the other side.
●
Fit the gear box onto the rear axle
from the left side (Standing at the rear of the
vehicle body). And make the motor on the
gear box pass through the hole in the vehicle
body.
●
Fit the driving wheel onto the rear axle,
keep it match with the gear box.
●
Fit a Ø10 washer onto the rear axle.
●
Fit a Ø10 locknut to the end of the rear
axle.
●
Insert the tabs on the hubcap into slots in
the driving wheel.
●
Slide the gear box (standing at back of vehicle body) onto the rear axle. “R” labeled gear box should be fit
to the “R” side of vehicle body; “L” labeled gear box should be fit to “L” side of vehicle body.
●
Slide the driving wheel onto rear axle, make it match with the gear box.
●
Slide a
Ø
10 washer.
●
Tighten the
Ø
10 locknut with a spanner.(Do not over tighten)
●
Repeat this procedure to assemble the other driving wheel to the rear axle.
●
Fit the hubcap to the driving wheel.
Driving wheel
Ø10
Locknut
Gear box
Rear
axle
Ø10
Washer
Hubcap
